Skip to content

Chimney Liner Installation in Canarsie, Brooklyn

Serving Canarsie and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (843) 895-6422

The short answer

Canarsie homes often need a new chimney liner after an oil-to-gas boiler conversion, when an old clay tile flue cracks, or when a new appliance needs a properly sized flue. We start with an inspection, then install a liner matched to your appliance and chimney. Plan the work outside heat season when you can.

A chimney liner is the channel inside your chimney that carries smoke and exhaust gases up and out of the house. In Canarsie, many homes are brick rowhouses, semi-attached two-family houses and detached homes with masonry chimneys. In these homes the liner is often original, cracked, or no longer matched to the appliance connected to it. ApexHearth Chimney Services installs new liners for boilers, furnaces, water heaters and fireplaces throughout the 11236 ZIP code. Our office is about 2 miles away, so getting from an inspection to a scheduled installation is straightforward.

Why Canarsie Chimneys Need New Liners

Older masonry chimneys were usually built with clay tile liners or, in some cases, no liner at all. Over the years, freeze-thaw cycles, settling and moisture can crack tiles and wash out mortar joints. Those gaps let heat reach the surrounding brick. They can also let exhaust, including carbon monoxide, seep into walls or living space. In attached and semi-attached houses, a chimney may run alongside a shared wall, so a sound flue protects more than one household.

Changing your heating system is one of the most common reasons to reline. When a New York City building converts its boiler from oil to gas, the chimney has to be evaluated as part of the work. A new liner is often needed because gas exhaust produces acidic condensate that can corrode a masonry flue. A newer, smaller or more efficient appliance may also need a flue sized for its exhaust, not for the larger boiler it replaced.

Chimney Liner Installation at a home

Signs Your Liner Needs Attention

None of these signs proves a liner has failed, but each is a reason to have the flue looked at before the next heating season:

  • Pieces of clay tile or crumbling masonry at the chimney base or in the cleanout
  • White staining or damp patches on chimney brick, inside or outside the house
  • Rust, water or debris where the boiler or water heater connects to the chimney
  • An exhaust smell or soot near the appliance
  • A carbon monoxide alarm going off with no clear cause
  • A planned oil-to-gas conversion or a new heating appliance

Inspection Comes Before Installation

The NFPA 211 standard calls for chimneys, fireplaces and vents to be inspected once a year, and it describes three inspection levels. A Level 1 inspection covers a system that hasn't changed. A Level 2 inspection applies when the system changes, such as a new appliance or a switch of fuel, or when the home is sold. A Level 3 inspection is used when a hidden hazard can only be reached by opening part of the chimney or building.

Most liner jobs follow a Level 2 inspection. This includes a camera look down the full length of the flue. Our certified technicians check the flue's size, its condition, any offsets or bends, and the cap and crown at the top. You'll get a plain explanation of what we found and what the liner should be, before any work begins.

Time for your annual chimney check?

Liner Options and What Installation Involves

For most Canarsie homes, the right choice is a stainless steel liner, rigid or flexible, sized to the appliance it will serve. Gas, oil and wood appliances each have their own requirements. Wood-burning fireplaces may also need insulation around the liner. We match the liner type and diameter to the appliance manufacturer's specifications and the shape of your chimney.

Installation typically means cleaning the existing flue and lowering the new liner from the roof. We then connect it to the appliance at the bottom and finish the top with a cap. Some chimneys need old tile broken out first so the liner fits. How long the job takes depends on the chimney's height, roof access and condition, and we'll tell you what to expect ahead of time.

Timing Around Heat Season

New York City's heat season runs from October 1 through May 31. During that period, building owners must keep apartments heated to the city's minimum temperatures. That matters if you rent out a unit in a two-family house. A boiler can't run safely while its chimney is being relined, so spring and summer are the easiest times for this work. If a liner problem turns up mid-winter, we'll plan the job to keep heating downtime as short as the conditions allow.

We also serve nearby Flatlands, East Flatbush, Marine Park, Mill Basin and Bergen Beach. Neighbors in those areas planning a conversion can schedule around the same window.

More services in Canarsie

Related

Chimney sweep cleaning a brick chimney on a rowhouse roof

Book Chimney Liner Installation in Canarsie

Serving Canarsie and nearby cities.

  • Diagnosis before any repair
  • Written price up front
  • Written price before we start

What to expect

How a visit goes

  1. Inspection comes first

    Before we sweep, patch or replace anything, we look at the whole system and tell you what we see in plain language.

  2. Your home stays clean

    We cover the work area, run vacuum equipment that contains soot and dust, and leave the room the way we found it.

  3. You make the call

    We lay out what is urgent, what can wait and what is fine as it is, so you can decide on repairs with the full picture.

FAQ

Common questions

Don’t see your question? Call (843) 895-6422 and we’ll talk it through.

Do I need a new liner if I'm switching my boiler from oil to gas?

Often, yes. In New York City, the chimney must be evaluated during an oil-to-gas conversion. A new liner is frequently needed because gas exhaust creates acidic condensate that can corrode a masonry flue.

Can my old clay tile liner be repaired instead of replaced?

Sometimes small sections can be repaired. Widespread cracking, missing tiles or a flue that's the wrong size for your appliance usually calls for a new liner. A camera inspection shows which situation you're in.

What type of liner do you install?

Most of the liners we install are stainless steel, sized to the appliance and the chimney. Wood-burning fireplaces may need insulation around the liner as well.

Will you need to open up my walls?

Usually not. Most liners go in from the roof through the existing flue. If an inspection points to a hidden hazard, a Level 3 inspection that opens part of the chimney or building may be recommended. We'll explain why before doing anything like that.

When is the best time to schedule liner installation in Canarsie?

Outside heat season, which runs October 1 through May 31 in New York City. Your boiler will be off during the work, so spring and summer cause the least disruption, especially if you have tenants.

Do you serve areas near Canarsie?

Yes. Besides Canarsie, we install chimney liners in Flatlands, East Flatbush, Marine Park, Mill Basin and Bergen Beach.

Find Out What Your Chimney or Vents Need

Schedule an inspection and we will show you what we find, explain your options and give you a written price before any work begins.

(843) 895-6422
Call (843) 895-6422 Request Service